SEND SMS
SEND EMAIL
 

Infrastructure & Facilities

Our Infrastructure

Powder Coating:

  • Seven tank process is used for pretreatment of sheet. After surface preparation it is coated with epoxy based powder to give thickness of 80-100 microns. It is baked in oven up to 180°c temperature for better adhesion.

Bending Machine:

  • Make: Arco Whitney
  • Capacity: 22 Ton

Time is reduced, suitable for 200 mm width and 12 mm thick Busbar and repeated operation.


Punching Machine:


  • Make: Arco Whitney Punch press 730*8 CC
  • Capacity:30 Ton

Scrap is reduced. Suitable for punching up to 20 mm diameter hole up to 12mm thick AL/CU busbar.


Ferrule Machine:


  • Letatwin LM-370A
  • Electronic lettering machine

It gives good aesthetic value to the job. Permanent marking ink is used. Variable sizes of sleeve are available. Number of letters can be accommodated in one ferrule. Aesthetically good, tube available in various sizes like 5 mm, 9 mm, 12 mm. Printing method used is Thermal Transfer with 300 dpi.

Manufacturing Facilities

Routine Test:

  • Inspection of assembly including wiring
  • Continuity Test
  • Insulation Resistance Test by (megger) 1000V DC
  • High voltage test by H V tester 2.5 KV for 1 min

Type Test :

  • Short circuit test as per IS 8623 (part I) 8.2.3-1993
  • Temperature rise test as per IS 8623 (part I) 8.2.1 -1993

Special Test:

  • Primary injection test
  • Secondary injection test
  • Heat run test


Reach Us
Amit Adangale (Sr. Executive Sales)
Sahara, No. 82/2 & 83, Hissa No. 2/2 Old N. D. A. Road, Shivane
Pune- 411023, Maharashtra, India



Call Us

Share Us

F GT L


Send E-mailSend SMS